Home BCM Cv Drum Effects Envelope Filter Gate Granular LFO MIDI Mix&Gain Modifier Modulation OSCs Pool Seq Shapers Tools

Seq: Flexor Ramp Tools

Default installation path: .../-=Flexor=-/Sequencers/Ramp

The Ramps descriptions itself can be found here.


"Gate 2 Ramp converts gate messages into a stepped

Ramp signal with a specified number of steps. Each time a gate on message is received the ramp will progress to the next step, until the maximum is reached. It is then reset to the first step and starts over from there. It also is possible to reset the ramp using another gate signal input to Ext Reset or by using the reset button. This module is ideal for using an external midi source to drive control and pitch sequencers."  (Flexor Manual)           MaxPoly:9

dspLoad 13.80/10.60/10.50

"This module sets the number of steps which will be played on any of the FleXor sequencer modules. It receives the frequency output from a ramp generator, and sends it to the Ramp input of any FleXor sequencer module. The sequencer can then be limited to play any range of its steps, by the ability to set the start and end of the sequence. The Poly Rhythmer adjusts the tempo of the sequencer, so it will always take the same time to complete the playback of a pattern, regardless of how many steps it is constructed of. This module is ideal for creation of polyrhythmic grooves and algorithmic music composition." (Flexor Manual)

Max. Poly: 16

dspLoad 11.70/8.50/8.50

"Ramp Distributor 2 divides one ramp signal into two

ramps and distributes them consecutively. It can be used

expand the number of steps in sequencers, or just to switch between ramp driven modules." (Flexor Manual) Max. Poly: 16

dspLoad 2.10/2.00/5.30

"Ramp Distributor 4 divides one ramp signal into four

ramps and distributes them consecutively. It can be used

expand the number of steps in sequencers, or just to switch between ramp driven modules." (Flexor Manual) Max. Poly: 16

dspLoad 9.00/5.70/5.80

"This module divides a ramp cycle into several ramps, thus multiplying its frequency. It is useful for synchronizing several sequencers that operate at different tempo divisions, enabling the creation of complex polyrhythmic patterns, or for controlling external pattern selections."  (Flexor Manual)

Max. Polyphony: 5

dspLoad 8.80/5.60/5.60

"Ramp Ranger allows an incoming ramp signal to be

scaled to a specified range of steps. The start and end

position of the ramp can be set, and the number of steps in the ramp can be set to match the device being controlled so that the start and end values are correct. This module is useful for making polyrhythmic patterns

as well as controlling pattern selection." (Flexor Manual)

Max. Polyphony: 16

dspLoad 2.70/5.90/2.70

"Seq Joiner 32 is used to join two 16 step sequencers

into one 32 step sequencer. It distributes the ramp signal

between the sequencers, and it also switches between the outputs of the individual sequencers to make it easy to join them together." (Flexor Manual)

Max. Polyphony: 16

dspLoad 4.20/7.40/4.30

"Seq Joiner 64 is used to join four separate 16 step

sequencer modules into one 64 step sequencer. It distributes the ramp signal between the sequencers, and it also switches between the outputs of the individual sequencers to make it easy to join them together."

(Flexor Manual) Max. Polyphony: 7

dspLoad 15.20/12.10/12.00

indicates the approximate time position of  Ramp and connected Seq modules.

dspLoad 0.30