Flexor3 ModSwitches are externally controlled, switching is not done manually but by control messages fed into the “Ramp” input. Consecutive playing order is achieved by using a Ramp module, other modules emitting bipolar values like Lfo, ControlSeq or constant valueB allow different playing orders. In contrary to the InterSeq modules, switching is sample-accurate (no cross-fading between input signals).

modSwitch1to2

dspLoad 1.70/1.70/4.90    
Max Poly: 16

modSwitch1to4

dspLoad 6.60/5.80/4.60    
Max Poly: 16

modSwitch1to8

dspLoad 13.60/10.50/10.40  
Max Poly: 8

modSwitch1to16

dspLoad 25.30/22.00/22.10
Max Poly: 4

modSwitch2to1

dspLoad 2.40/5.60/2.30  
Max Poly: 16

modSwitch4to1

dspLoad 9.70/6.50/6.50  
Max Poly: 14

modSwitch8to1

dspLoad 15.60/12.30/12.30    
Max Poly: 7

modSwitch16to1

dspLoad 28.30/25.20/25.10    
Max Poly: 3 BackModule250x10 596e81cw

level switches: input can be switched by control signals ([swi] input), to be routed to one of the four outputs. threshold values can be assigned freely, but should be in ascending order (thr1<thr2<thr3). the thr0 value (which will control the changover to output1) is always [min]. 

LevelSw1to4MkII

dspLoad 1.30
cwm download

LevelSw1to4MkIII

dspLoad 2.00/2.00/5.20
as above, but thr values can be modulated (switchable).
cwm download

Level-Switch 1 to 4

dspLoad 1.10/4.30/1.10

Level-Switch 4 to 1

dspLoad 1.20/4.40/1.10

SyncSwitches: Switching occurs whenever input exceeds a given threshold. 

syncSw2to1

dspLoad 2.10/2.00/5.30
if In is within range, in1->out; else in2->out.   cwm download

SyncSw1to4knb

dspLoad 10.10/6.90/6.90
threshold is determined by controls [Lev2], [Lev3], [Lev4].

SyncSwitch 1 to 4

dspLoad 9.10/5.80/5.80
threshold is determined by mod inputs  [Lev2], [Lev3], [Lev4].