Flexor3 ModSwitches are externally controlled, switching is not done manually but by  control messages fed into the “Ramp” input. Consecutive playing order is achieved by using a Ramp module, other modules emitting bipolar values like Lfo, ControlSeq or constant valueB allow different playing orders. In contrary to the InterSeq modules, switching is sample-accurate (no cross-fading between input signals).

modSwitch1to2

dspLoad 1.70/1.70/4.90    
Max Poly: 16

modSwitch1to4

dspLoad 6.60/5.80/4.60    
Max Poly: 16

modSwitch1to8

dspLoad 13.60/10.50/10.40  
Max Poly: 8

modSwitch1to16

dspLoad 25.30/22.00/22.10
Max Poly: 4

modSwitch2to1

dspLoad 2.40/5.60/2.30  
Max Poly: 16

modSwitch4to1

dspLoad 9.70/6.50/6.50  
Max Poly: 14

modSwitch8to1

dspLoad 15.60/12.30/12.30    
Max Poly: 7

modSwitch16to1

dspLoad 28.30/25.20/25.10    
Max Poly: 3

 

 

CWMod level switches: input can be switched by control signals (“swi” input) to be routed to one of the four outputs. threshold values can be assigned freely, but should be in ascending order (thr1<thr2<thr3). the thr0 value (which will control the changover to output1) is always -64 (min).

LevelSw1to4MkII

dspLoad 1.30
cwm download

LevelSw1to4MkIII

dspLoad 2.00/2.00/5.20
as above, but thr values can be modulated (switchable).
cwm download

syncSw2to1

dspLoad 2.10/2.00/5.30 download
if In is within range, in1->out; else in2->out

 

BackModule300x10 596e81cw 

Flexor3 InterSeq modules perform crossfading between the 4, 8 or 16 inputs. Consecutive playing order is achieved by using a Ramp module; other modules like Lfo or ControlSeq allow different playing orders.

InterSeq4

dspLoad 13.90/10.60/10.70 
Max Poly: 8

InterSeq8

dspLoad 24.30/21.00/21.10   
Max Poly: 4

InterSeq16

dspLoad 45.30   
Max Poly: 2

Flexor3 Threshold Switches activate if a given threshold of a control signal connected to [Switch] has been exceeded. E.g., if Thr. is set to 0, a control signal with any value below 0 will select Out- or Input 1, and any signal greater or equal 0 will select Out- ot Input2.

thrSwitch 1to2

dspLoad 2.40/5.60/2.30  
Max Poly: 16

thrSwitch 2to1

dspLoad 3.10/6.20/3.10  
Max Poly: 16

Flexor3 NoteDrivenSwitch selects one of the four inputs by comparing them to the notes/noteValues of the four text faders.

noteDrivenSwitch

dspLoad 2.20/4.20/3.50  
Max Poly: 16

 

 

 

 

Thr2SigSw1to2

dspLoad 1.70/1.70/4.90
cwm download

Thr2SigSw2to1

dspLoad 2.30/4.30/3.50
cwm download