gate>val (except random)

dspLoad 7.00/3.80/3.70
Every time a gate message is received, a specified value (“Add”) is added to a base value (“Min”) up to the maximum value (“Max”). When the maximum value is reached, the procedure starts from the beginning.

dspLoad 0.60 outputs a specified (sync) value when gateOn is received. cwm download

Dsp load: 0.90    Flexor3
GateOn> +1 on [Out]
GateOff> +1 on [Inv]

val>gate

Dsp load:  8.90/5.70/5.60           
gateOn if a given threshold value of the audio input is reached. (monophonic)

dspLoad 0.90/0.90/1.00
download

DspLoad: 0.50/2.30/1.80
gateOn if input A < B. Sens : trigger hold time

DspLoad: 0.50/2.30/1.80
gateOn if input A < X (can be a switched between unip. or bip.)
Sens: trigger hold time

dspLoad 14.60/11.30/11.40
creates gate messages depending on volume changes of the audio input: if input level exceeds thresh level=>gateOn; if input level is under thresh level => gateOn at the [!G] outputs. For easier editing, the L1 threshold setting can be copied to threshold 2 and 3 (Link2 resp. 3 buttons). In this case L2 resp. L3 controls are ignored. Threshold levels can be modified by signals connected to  the L1-L3 mod inputs, modulation amount is controlled by the L1-L3 mod controls.

gate distributors

dspLoad 8.50/5.20/5.20
toggles between gateOut1 and 2

Dsp load:  0.00
routes an incoming gate signal to one of the two gate outputs, depending on either their MidiNote or another unipolar control message fed into the Val input.

Gate
Gate1
Gate2