these modules output control messages on 4 resp. 6 or 8 different “channels”.
*the potis in the “output” row just show the actual output of the module,  they cannot be edited.
*with the potis below the fade time can be edited. min. val is about 2sec, max. is ~ 1min. if the +/- button beside the poti is clicked, fadetime is almost zero.
*the potis in the “startVal” row define the final output. there is also a unipol/bipol switch.
*the settings of the four controllers are stored in a “snap”. 8 snaps are available.
*the “PSw” pad has to be connected to a MorphSwitch module, to switch between the snaps.
*to copy the settings from one snap to the following snap, the tiny link/lock buttons have to be switched to “->”. caution: all settings will be overwritten (no redo).

Control4

dspLoad 0.20
this controlUnit has no dezip.
cwm download

ControlUnit1xub

dspLoad 1.30
unipolar/bipolar fader CU.
cwm download

ControlUnit2xy

dspLoad 0.00
with direct MIDI CC# input (-1 = no CC#)
cwm download
 

ControlUnit4

dspLoad 0.00
standard CU.
cwm download

ControlUnit4BMod

dspLoad 1.20
for external async signals. startVal values can’t be edited.
cwm download

ControlUnit4NoteVal

dspLoad 0.20
outputs note values.
cwm download

ControlUnit4F

dspLoad 0.00
outputs unipolar messages, for mixing applications.
cwm download

ControlUnit6

dspLoad 0.00
like ControlUnit4, but with 6 control outputs.
cwm download

ControlUnit8F

dspLoad 0.00
like ControlUnit4F, but with 8 control outputs.
cwm download

ControlUnit9F

dspLoad 0.00
like ControlUnit8F, but with 9 control outputs.
cwm download